Installation Documentation
Coil Installation Guides
Outlines how to install the control input for a heat reclaim on an i-Controller 2.0 revision 300 or greater unit.
Outlines how to install the control input for a heat reclaim on an i-Controller revision 112 unit.
Outlines how to seal the heat reclaim pipe chase.
Outlines how to remove and install a heat reclaim coil in 9-30 ton units.
Controls Conversion Guides
Outlines how to convert an n-Controller 575V 40-70 ton unit to an i-Controller revision 200.
Outlines how to convert a 88AO 480V 6-10 ton unit to an i-Controller revision 201.
Outlines how to convert a 88AO 480V 13-30 ton unit to an i-Controller revision 201.
Outlines how to convert a Jace 575V 20-30 ton WSHP unit to an i-Controller revision 200.
Outlines how to convert a Jace 575V 40-70 ton MPU unit to an i-Controller revision 200.
Outlines how to convert a Jace 575V 40-70 ton WSHP unit to an i-Controller revision 200.
Outlines how to convert a MF88AO 208V 20-30 ton unit with an ERV to an i-Controller revision 112.
Outlines how to convert a Jace controller 575V 20-30 ton unit to an i-Controller revision 200.
Outlines how to convert an n-Controller 575V 20-30 ton unit to an i-Controller revision 200.
Outlines how to convert an E2 controller 208V 20-30 ton unit to an i-Controller revision 112 an expansion board.
Outlines how to convert an E2 controller 208V 20-30 ton unit to an i-Controller revision 112 without an expansion board.
Outlines how to convert a Jace controller 208V 20-30 ton unit to an i-Controller revision 112.
Outlines how to add an isolation relay for heat reclaim during a conversion to i-Controller.
Outlines how to convert a MF168AO 208V 20-30 ton unit to an i-Controller revision 112.
Misc. Installation Guides
Outlines how to select which zones/areas will be treated by the VAV in i-Controller REV.112 units.
Outlines IO points for i-Controller 2.0.
Outlines how to wire an i-Controller expansion module to a stand alone Price VAV for units with i-Controller revision 200 or above.
Outlines how to wire an i-Controller expansion module to a stand alone Price VAV for units with i-Controller revision 112.
Installation, Operation & Maintenance manual for RN series units.
Outlines how to install hurricane brackets provided by Flo.
Outlines how to install a condensate drain pan float switch.
Sensor Installation Guides
Outlines how to install the Carel Space Temp/RH combo sensor that is typically included in i-Controller 2.0 units.
Outlines how to install the CPC space/RH combo sensor that is often used with i-Controller units.
Outlines recommended positioning of space temperature and humidity sensor within the store.
Outlines how to install a Flo provided supply air temperature sensor.
Start-Up Approval Forms
Outlines what needs to be completed by the on-site team and signed off prior to the Flo provided start-up.