i-Controller 2.0 VCCX-IP Update Via USB Drive – CN-IC2-20
September 11, 2024
No Comments
This guide outlines how to prepare a USB thumb drive for VCCX‐IP updating and how to execute the VCCX‐IP update.
This guide outlines how to prepare a USB thumb drive for VCCX‐IP updating and how to execute the VCCX‐IP update.
Outlines how to verify compressor operation using RSMD overrides on i-Controller 2.0 units in low ambient conditions.
Outlines how to configure the BACnet communication settings for units with an i-Controller 2.0.
Outlines how to utilize the air balancing mode in the i-Controller 2.0.
Outlines IO points for i-Controller 2.0.
Outlines how to install the control input for a heat reclaim on an i-Controller 2.0 revision 300 or greater unit.
Outlines how to install the Carel Space Temp/RH combo sensor that is typically included in i-Controller 2.0 units.
Outlines how to override compressors in an i-Controller 2.0 unit.
Overview of i-Controller 2.0 BACnet status parameters that can be mapped as “Outputs” to the BMS to provide real-time status of the Flo unit.
Outlines how to perform an i-Controller firmware/program update using a micro USB drive or a micro USB adapter.
"*" indicates required fields