i-Controller Sub-Panel Assembly Wiring Guide – SU-IC1-02
Outlines how to wire an i-Controller sub-assembly before a start-up is performed. This guide applies to any start-up with i-Controller 1.0 that produced after September
Outlines how to wire an i-Controller sub-assembly before a start-up is performed. This guide applies to any start-up with i-Controller 1.0 that produced after September
Overview of i-Controller Modbus status parameters that can be mapped as “Outputs” to the BMS to provide real-time status of the Flo unit.
Outlines how to use the i-Controller REV.201 Water Balance Mode for units with water source condensers.
Overview of i-Controller BACnet status parameters that can be mapped as “Outputs” to the BMS to provide real-time status of the Flo unit.
Outlines how to select which zones/areas will be treated by the VAV in i-Controller REV.112 units.
Outlines how to configure the BACnet communication settings for units with an i-Controller REV.201.
Outlines Visograph navigation for units with i-Controller revision 201.
Outlines how to troubleshoot a CPC RH Sensor (part # 203-5751 or 203-5752).
Outlines how to wire an i-Controller expansion module to a stand alone Price VAV for units with i-Controller revision 200 or above.
Outlines how to wire an i-Controller expansion module to a stand alone Price VAV for units with i-Controller revision 112.